Electrical & Technical Toolkit
Browser-local toolkit · Version 3

Electrical & Technical Toolkit

Enter plain numbers, choose units from the dropdowns, then solve all related values. All calculations run locally in the browser.

Unit Converter — convert distance, weight, speed, time, energy, temperature, and frequency
Enter a valid value.
Ohm’s Law & Power Solver — enter any two independent values; solve all four
Enter any two independent values.
Frequency & Period Solver — enter frequency or either period form
Enter frequency or period.
Wire Voltage-Drop Calculator — calculate drop, delivered voltage, and maximum length together
DC / single-phase estimate. Validate conductor material, temperature, code requirements, and AC/power-factor considerations separately.
Enter current and wire size; then provide a run length and/or allowed drop.
RC Circuit Calculator — solve R, C, time constant, cutoff, and timing together
Enter R/C, R/τ, C/τ, R/fc, or C/fc.
LC Circuit Calculator — enter any two values; solve resonance and reactance
Enter any two compatible values.
Component Network Calculator — equivalent or one missing resistor, capacitor, or inductor
Enter positive values or use one ? with a target equivalent.
Battery Runtime & Load-Sequence Calculator — primary runtime, post-shutdown loads, and pack totals

Enter pack details and whatever loads are known. Secondary loads run after the primary load stops; optionally mark a secondary load as also active during the primary period.

Secondary / standby loads

These continue after the main load is off. Check a row if it also runs during the main-load period.
Enter voltage, capacity, and any applicable primary or secondary loads.
RF / SATCOM Helpers — power conversion, cable loss, link budget, and VSWR
Enter any applicable RF values.
Semiconductor Basics — BJT base current and op-amp gain
Choose a tool and enter its values.
Component Value Helper — 3-digit resistor, capacitor, and inductor codes
Choose a component code.

Use estimates responsibly: validate units, formulas, component ratings, applicable standards, installation conditions, and safety margins before relying on a result.