Battery Runtime & Load Sequence Calculator
Model main equipment, persistent loads, and standby loads that remain after the main equipment is turned off. Get pack totals, phase-by-phase drain, remaining capacity, runtime, substituted calculation steps, and a plain-language narrative.
How it works: Enter the voltage and capacity for one cell or a base pack. Series and parallel counts scale those values into pack totals. Add the main load and any secondary loads. Mark a secondary load if it also runs during the main-load phase.
Battery / Pack Configuration
Enter individual-cell data when known. Series and parallel values scale those inputs into pack totals. If a datasheet or label already gives a complete-pack value, use the matching override below.
Complete-pack overrides — use values printed on a battery or datasheet
A capacity override in Wh or kWh is converted to Ah using the final pack voltage. If both individual-cell inputs and overrides are filled, the override is used and the calculation steps will say so.
Main / Active Load
This load is switched off after the entered main-load duration.
Secondary / Standby Loads
All listed loads run after the main load is disabled. Mark the checkbox for loads that also run during the active phase.
Formula reference and assumptions
Pack voltage = voltage override, or base voltage × series cellsPack capacity = capacity override, or base capacity × parallel stringsStored energy = pack voltage × pack capacityUsable capacity = pack capacity × usable factorCurrent from power = power ÷ pack voltageConsumed capacity = current × timeRemaining capacity = usable capacity − consumed capacityStandby runtime = remaining capacity ÷ standby current